Ping Putter Tip Size

Does anyone know the tip size of a Ping JB5 putter and if it has a ball bearing down the shaft? Going to try and order a shaft before I get the club. Thanks.
Mike, Aiken, South Carolina, USA

Mike,

It is .355 taper.

Regards,

Jeff

July 17th, 2014. Read more articles on Specs.

Wee Scot Putter

I have a Wee Scot Putter from either the 60’s or 70’s it is like a mallet, round back, centerline groove on top, brass or similar material with a black hard rubber face insert. I have found what I think is the Mfg. Co. out of Montgomery, AL through research. Any info would be great. Thanks.
Stephen, Pelzer, South Carolina, USA

Stephen,

Sorry. I have no knowledge of this putter.

Regards,

Jeff

July 16th, 2014. Read more articles on Products.

Mizuno JPX 800 Iron Reshaft

I am thinking of re-shafting my Mizuno JPX 800 HD irons but I am unable to find the shaft specification. i.e., .350, .355, .370. Could help me?
Jack, Malvern, Pennsylvania, USA

Jack,

As these were cast and most Mizuno cast clubs are .370″, that would be my estimation…’not 100% sure though.

Regards,

Jeff

July 11th, 2014. Read more articles on Specs.

Ping Club Restoration

I have set of Ping irons and woods that I would like to restore to original condition again. Where do I go to have this done?
David, Fort Wayne, Indiana, USA

David,

I’d recommend the Golfworks, www.golfworks.com

Regards,

Jeff

July 7th, 2014. Read more articles on Repair.

Callaway Iron Grips

What size grips do I need for my set of Callaway X20 irons with graphite shafts? Thanks.
John, Williamstown, New Jersey, USA

John,

They will be .580 core.

Regards,

Jeff

June 29th, 2014. Read more articles on Grips.

« Older articles

Newer articles »